by Robert Connell Clarke
General Traits
Size and Yield
The size of an individual Cannabis plant is determined by environmental factors such as room for root and shoot growth, adequate light and nutrients, and proper irrigation. These environmental factors influence the phenotypic image of genotype, but the genotype of the individual is responsible for overall variations in gross morphology, including size. Grown under the same conditions, particularly large and small individuals are easily spotted and selected. Many dwarf Cannabis plants have been reported and dwarfism may be subject to genetic control, as it is in many higher plants, such as dwarf corn and citrus. Cannabis parents selected for large size tend to produce offspring of a larger average size each year. Hybrid crosses between tall (Cannabis sativa-Mexico) strains and short (Cannabis ruderalis-Russia) strains yield F1 offspring of intermediate height (Beutler and der Marderosian 1978). Hybrid vigor, however, will influence the size of offspring more than any other genetic factor. The increased size of hybrid offspring is often amazing and accounts for much of the success of Cannabis cultivators in raising large plants. It is not known whether there is a set of genes for “gigantism” in Cannabis or whether polyploid individuals really yield more than diploid due to increased chromosome count. Tetraploids tend to be taller and their water requirements are often higher than diploids. Yield is determined by the overall production of fiber, seed, or resin and selective breeding can be used to increase the yield of any one of these products. However, several of these traits may be closely related, and it may be impossible to breed for one without the other (gene linkage). Inbreeding of a pure strain increases yield only if high yield parents are selected. High yield plants, staminate or pistillate, are not finally selected until the plants are dried and manicured. Because of this, many of the most vigorous plants are crossed and seeds selected after harvest when the yield can be measured.
Vigor
Large size is often also a sign of healthy vigorous growth. A plant that begins to grow immediately will usually reach a larger size and produce a higher yield in a short growing season than a sluggish, slow-growing plant. Parents are always selected for rich green foliage and rapid, responsive growth. This will ensure that genes for certain weaknesses in overall growth and development are bred out of the population while genes for strength and vigor remain..
Adaptability
It is important for a plant with a wide distribution such as Cannabis to be adaptable to many different environmental conditions. Indeed, Cannabis is one of the most genotypically diverse and phenotypically plastic plants on earth; as a result it has adapted to environmental conditions ranging from equatorial to temperate climates. Domestic agricultural circumstances also dictate that Cannabis must be grown under a great variety of conditions. Plants to be selected for adaptability are cloned and grown in several locations. The parental stocks with the highest survival percentages can be selected as prospective parents for an adaptable strain. Adaptability is really just another term for hardiness under varying growth conditions.
Hardiness
The hardiness of a plant is its overall resistance to heat and frost, drought and overwatering, and so on. Plants with a particular resistance appear when adverse conditions lead to the death of the rest of a large population. The surviving few members of the population might carry inheritable resistance to the environmental factor that destroyed the majority of the population. Breeding these survivors, subjecting the offspring to continuing stress conditions, and selecting carefully for several generations should result in a pure-breeding strain with increased resistance to drought, frost, or excessive heat.
Disease and Pest Resistance
In much the same way as for hardiness a strain may be bred for resistance to a certain disease, such as damping-off fungus. If flats of seedlings are infected by damping-off disease and nearly all of them die, the remaining few will have some resistance to damping-off fungus. If this resistance is inheritable, it can be passed on to subsequent generations by crossing these surviving plants. Subsequent crossing, tested by inoculating flats of seedling offspring with damping-off fungus, should yield a more resistant strain.
Resistance to pest attack works in much the same way. It is common to find stands of Cannabis where one or a few plants are infested with insects while adjacent plants are untouched. Cannabinoid and terpenoid resins are most probably responsible for repelling insect attack, and levels of these vary from plant to plant. Cannabis has evolved defenses against insect attack in the form of resin-secreting glandular trichomes, which cover the reproductive and associated vegetative structures of mature plants. Insects, finding the resin disagreeable, rarely attack mature Cannabis flowers. However, they may strip the outer leaves of the same plant because these develop fewer glandular trichomes and protective resins than the flowers. Non-glandular cannabinoids and other compounds produced within leaf and stem tissues which possibly inhibit insect attack, may account for the varying resistance of seedlings and vegetative juvenile plants to pest infestation. With the popularity of greenhouse Cannabis cultivation, a strain is needed with increased resistance to mold, mite, aphid,- or white fly infestation. These problems are often so severe that greenhouse cultivators destroy any plants which are attacked. Molds usually reproduce by wind-borne spores, so negligence can rapidly lead to epidemic disaster. Selection and breeding of the least infected plants should result in strains with increased resistance.
Maturation
Control of the maturation of Cannabis is very important no matter what the reason for growing it. If Cannabis is to be grown for fiber it is important that the maximum fiber content of the crop be reached early and that all of the individuals in the crop mature at the same time to facilitate commercial harvesting. Seed production requires the even maturation of both pollen and seed parents to ensure even setting and maturation of seeds. An uneven maturation of seeds would mean that some seeds would drop and be lost while others are still ripening. An understanding of floral maturation is the key to the production of high quality Cannabis. Changes in gross morphology are accompanied by changes in cannabinoid and terpenoid production and serve as visual keys to determining the ripeness of Cannabis flowers.
A Cannabis plant may mature either early or late, be fast or slow to flower, and ripen either evenly or sequentially.
Breeding for early or late maturation is certainly a reality; it is also possible to breed for fast or slow flowering and even or sequential ripening. In general, crosses between early-maturing plants give rise to early-maturing offspring, crosses between late-maturing plants give rise to late maturing offspring, and crosses between late- and early maturing plants give rise to offspring of intermediate maturation. This seems to indicate that maturation of Cannabis is not controlled by the simple dominance and recessiveness of one gene but probably results from incomplete dominance and a combination of genes for separate aspects of maturation. For instance, Sorghum maturation is controlled by four separate genes. The sum of these genes produces a certain phenotype for maturation. Although breeders do not know the action of each specific gene, they still can breed for the total of these traits and achieve results more nearly approaching the goal of timely maturation than the parental strains.
Root Production
The size and shape of Cannabis root systems vary greatly. Although every embryo sends out a taproot from which lateral roots grow, the individual growth pattern and final size and shape of the roots vary considerably. Some plants send out a deep taproot, up to 1 meter (39 inches) long, which helps support the plant against winds and rain. Most Cannabis plants, however, produce a poor taproot which rarely extends more than 30 centimeters (1 foot). Lateral growth is responsible for most of the roots in Cannabis plants. These fine lateral roots offer the plant additional support but their primary function is to absorb water and nutrients from the soil. A large root system will be able to feed and support a large plant. Most lateral roots grow near the surface of the soil where there is more water, more oxygen, and more available nutrients. Breeding for root size and shape may prove beneficial for the production of large rain- and wind resistant strains. Often Cannabis plants, even very large ones, have very small and sensitive root systems. Recently, certain alkaloids have been discovered in the roots of Cannabis that might have some medical value. If this proves the case, Cannabis may be cultivated and bred for high alkaloid levels in the roots to be used in the commercial production of pharmaceuticals. As with many traits, it is difficult to make selections for root types until the parents are harvested. Because of this many crosses are made early and seeds selected later.
Branching
The branching pattern of a Cannabis plant is determined by the frequency of nodes along each branch and the extent of branching at each node. For examples, consider a tall, thin plant with slender limbs made up of long internodes and nodes with little branching (Oaxaca, Mexico strain). Compare this with a stout, densely branched plant with limbs of short internodes and highly branched nodes (Hindu Kush hashish strains). Different branching patterns are preferred for the different agricultural applications of fiber, flower, or resin production. Tall, thin plants with long internodes and no branching are best adapted to fiber production; a short, broad plant with short internodes and well developed branching is best adapted to floral production. Branching structure is selected that will tolerate heavy rains and high winds without breaking. This is quite advantageous to outdoor growers in temperate zones with short seasons. Some breeders select tall, limber plants (Mexico) which bend in the wind; others select short, stiff plants (Hindu Kush) which resist the weight of water without bending.
Sex
Attempts to breed offspring of only one sexual type have led to more misunderstanding than any otherfacet of Cannabis genetics. The discoveries of McPhee (1925) and Schaffner (1928) showed that pure sexual type and hermaphrodite conditions are inherited and that the percentage of sexual types could be altered by crossing with certain hermaphrodites. Since then it has generally been assumed by researchers and breeders that a cross between ANY unselected hermaphrodite plant and a pistillate seed-parent should result in a population of all pistillate offspring. This is not the case. In most cases, the offspring of hermaphrodite parents tend toward hermaphrodism, which is largely unfavorable for the production of Cannabis other than fiber hemp. This is not to say that there is no tendency for hermaphrodite crosses to alter sex ratios in the offspring. The accidental release of some pollen fro predominantly pistillate hermaphrodites, along with the complete eradication of nearly every staminate and staminate hermaphrodite plant may have led to a shift in sexual ratio in domestic populations of sinsemilla Cannabis. It is commonly observed that these strains tend toward 60% to 80% pistillate plants and a few pistillate hermaphrodites are not uncommon in these populations.
However, a cross can be made which will produce nearly all pistillate or staminate individuals. If the proper pistillate hermaphrodite plant is selected as the pollen parent and a pure pistillate plant is selected as the seed parent it is possible to produce an F1, and subsequent generations, of nearly all pistillate offspring. The proper pistillate hermaphrodite pollen-parent is one which has grown as a pure pistillate plant and at the end of the season, or under artificial environmental stress, begins to develop a very few staminate flowers. If pollen from these few staminate flowers forming on a pistillate plant is applied to a pure pistillate seed parent, the resulting F1 generation should be almost all pistillate with only a few pistillate hermaphrodites. This will also be the case if the selected pistillate hermaphrodite pollen source is selfed and bears its own seeds. Remember that a selfed hermaphrodite gives rise to more hermaphrodites, but a selfed pistillate plant that has given rise to a limited number of staminate flowers in response to environmental stresses should give rise to nearly all pistillate offspring. The F1 offspring may have a slight tendency to produce a few staminate flowers under further environmental stress and these are used to produce F2 seed. A monoecious strain produces 95+% plants with many pistillate and staminate flowers, but a dioecious strain produces 95+% pure pistillate or staminate plants. A plant from a dioecious strain with a few intersexual flowers is a pistillate or staminate hermaphrodite. Therefore, the difference between monoecism and hermaphrodism is one of degree, determined by genetics and environment.
Crosses may also be performed to produce nearly all staminate offspring. This is accomplished by crossing a pure staminate plant with a staminate plant that has produced a few pistillate flowers due to environmental stress, or selfing the latter plant. It is readily apparent that in the wild this is not a likely possibility. Very few staminate plants live long enough to produce pistillate flowers, and when this does happen the number of seeds produced is limited to the few pistillate flowers that occur. In the case of a pistillate hermaphrodite, it may produce only a few staminate flowers, but each of these may produce thou sands of pollen grains, any one of which may fertilize one of the plentiful pistillate flowers, producing a seed. This is another reason that natural Cannabis populations tend toward predominantly pistillate and pistillate hermaphrodite plants. Artificial hermaphrodites can be produced by hormone sprays, mutilation, and altered light cycles. These should prove most useful for fixing traits and sexual type. Drug strains are selected for strong dioecious tendencies. Some breeders select strains with a sex ratio more nearly approaching one than a strain with a high pistillate sex ratio. They believe this reduces the chances of pistillate plants turning hermaphrodite later in the season.